The scanner does not output data and beeps three times at every scan.
This symptom indicates that a three-scan setting is not yet completed. Some
settings take three scans to complete, they are:
6
Setup Code Disabled
When scanning the Default barcode, the scanner is not reset to Default
but output data “.A001$”.
Scan SETUP CODE ON(Group 1) to enable all setup codes.
The scanner does not scan when the trigger is depressed.
Scanner seems to be performing as usual, but no data is being output.
Computer Type
(Group 1)
Interfaces Selection
(Group 1)
Kind of Troubles
No
Symptoms
Solutions
Figure 2
1
2
3
1. Unplug the cable from the host computer.
2. Plug the cable back into the host computer.
3. Set the scanner to the exact computer type immediately.
1. Unplug the cable from the host computer.
2. Plug the cable back into the host computer.
3. Set the scanner to the correct interface. The cable needs
to match the interface.
1. Follow the procedures for these settings at the
appropriate pages.
2. The scanner will beep three times for an incomplete
setting.
3. Scan RESET to try a setting again.
1. Preamble, Postamble (Group4)(page 14)
2. Accuracy Adjustment (Group5)(page 15)
3. Customer ID Configuration (Group 8 & 9)(page 18-19)
4. Min/Max Length (Group 17, 18, 19, 20, 21, 22, 25)
5. ABC Codabar (Group 22 & 23)
6. CX-Codabar (Group 22 & 23)
7. Coupling Codabar (Group 22 & 23)
8. EAN 128 (Group 31)
Setting Procedure
have not completed
( Setting Need Triple
Shot scanning )
----------------------------
Group - 4, 5, 8, 9, 17,
18, 19, 20, 22, 23, 25,
31
Limitation of length of
the bar code
The scanner is reading correctly, except for certain bar codes of a certain length.
4
Reset the Min/Max setting for the bar code symbology
affected.
5
RS232 Protocol
Communication setting
problem
The scanner appears to be working in the RS-232 interface, but no data
is output.
Ensure the correct RS-232 communication parameters
have been set: Baud Rate, Handshaking, Stop Bits, Data
Bits, and Parity. These settings must be the same for both
the scanner and the host.
Summary of Contents for BTScan
