IDS GeoRadar IBIS-ArcSAR, User Manual

Page: 65 / 78

5 FIRST IBIS-ArcSAR START UP
IDS GeoRadar S.r.l. Confidential Information - Do Not Distribute MNG/2017/0016 Rev 1.0 65/ 78

turn the PSU Isolation Point switch on (
Fig. 144
);
Fig. 144 – PSU Isolation Point switch turned on

open the PSU door using the black handle (green). Secure the door
fixing it with the lever placed on the left lower corner (
Fig. 145
);
Fig. 145 – PSU panel

on the Power Module, turn the red switch to position ON (
Fig. 146
),
the battery indicator will show the battery’s level and the LED will
turn on;
Fig. 146 – Turning on the PSU ON/OFF switch

push the ENABLE and AC INPUT switches placed on the Power
Module. This operation switch on the Power Module, the Control
Module and the Green Module.
Fig. 147 – Turning on the ENABLE switch in the Power Module on PSU panel
If the mains AC input is available on site, the AC Mains cable has to be used
(
Fig. 148
left). The blue end of this cable has to be plugged to the external
supply connection and the other end of the cable has to be plugged to the
Mains Input connection in I/O interface panel on the rear side of the IBIS-
ArcSAR (
Fig. 148
right).