Electronic Pushbutton Locks
EL740S
© 2017 IDN, Inc. All rights reserved.
0817
A
A
A
A
A
A
A
A
SET
DEL
HOW TO ADD AN USER CODE
1
2
3
4
5
6
7
8
9
0
C
26
SETUP MODE
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice.
You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [20]and press button .
Enter new user code (four to six digits) and press button .
The Red LED will light up for 10 seconds. The lockset will have the new user code set.
(If a number of user codes are to be added at the same time, enter new user code and press ,
and repeat above step prior to the indicator light timing out 10 seconds after the last press of a
keypad button.)
Note:
1.The lockset will go back to the standby status if no
button is pressed in 10 seconds after accessing setup
mode.
A
A
A
A
A
A
A
A
SET
DEL
1
2
3
4
5
6
7
8
9
0
C
27
SETUP MODE
HOW TO ADD A PROXIMITY CARD (only available for Proximity Card Electronic Deadbolt)
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds.
The Red LED will light up and beep twice.You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [20] and press button . Touch the inductive zone with the card.
The Red LED will light up for 10 seconds. The lockset will have the new card set.
(If a number of proximity cards are to be added at the same time, use new card to touch the inductive zone,
and repeat above step prior to the indicator light timing out 10 seconds after the last press of a
keypad button.)
Note:
1.The lockset will go back to the standby status if no
button is pressed in 10 seconds after accessing setup
mode.
2.Please use or purchase proximity cards compatible with
standard Mifare -13.56 MHz if you want to have more
than one proximity card.
3.Proximity card capacity: 10 sets maximum.
All manuals and user guides at all-guides.com
