Electronic Pushbutton Locks
EL740S
© 2017 IDN, Inc. All rights reserved.
0817
We recommend to re-install the decorative cover after completing setup mode in page 25 to page 42.
24
INSTALLATION INSTRUCTIONS
If you want to remove the decorative cover,
please hold the bottom of the decorative cover and pull it
toward yourself.
A
A
A
A
A
A
A
A
SET
DEL
SETUP MODE
HOW TO CHANGE PROGRAMMING CODE
Important:
The pre-set programming code is 1-2-3-4-5-6.
Please change the programming code before operating the lockset.
1
2
3
4
5
6
7
8
9
0
C
25
Steps are as follows:
1. Press and hold [SET] button for over 2 seconds. The Red LED will light up and beep twice.
You are now under setup mode.
2. Enter 123456 (or current programming code) and then press button .
Enter [10] and press button .
Enter new programming code (six digits) and press button .
The Red LED will light up for 10 seconds. The lockset will have the new programming code set.
Note:
1.The lockset will go back to the standby status if no button is
pressed in 10 seconds after accessing setup mode.
2.If you enter new programming code in 10 seconds after accessing
setup mode, the last programming code will be stored in the
lockset.
All manuals and user guides at all-guides.com
