COS-100HD-B User
’s Guide
49
7.6.6 [ C12 ] Output status On-screen-display
You can display the signal status that is output to the receiver on the screen.
Setting values
on : OSD enabled
oFF : OSD disabled [Default]
<OutputStatus> [COS-R100HD-B]
[MonitorStatus]
Color :8bit YCbCr4:4:4
Mode :HDMIMode
Audio :L-PCM 48kHz 2ch
HDCP :Support
[OutStatus]
Color :RGB
HDCP :Auth OK
[TestPattern(RX)]
Format :OFF
[Version(RX)]
Soft/Hard:1.00/1.00
②
⑤
④
①
③
[Fig. 7.7] Output status OSD
[Table 7.15] Description of input status
#
Description
①
Model name
②
Sink device status
Color : Color depth, color space
Mode : mode (HDMI / DVI)
Audio : Audio format, sampling frequency, the number of audio channels
HDCP : Supported / Not supported
③
Output signal status
Color : Color space
HDCP : HDCP Authentication Status
④
Data of output test pattern information
Format : Resolution of output test pattern, Vertical synchronous frequency
(When no test pattern is output:
“OFF”)
⑤
Version
Soft / Hard: Software version / Hardware version
Note:
If the on-screen display function is set for both transmitter and receiver, the input status of the
transmitter is not displayed.
