12
DC-TH
201x Installation Guide
4. Notes on Use
1.1 Notes on installation
- When the camera is registered to NVR for the first time, the default resolution is set as the
highest - the visual mode resolution. Therefore, the resolution must be adjusted to thermal image
viewable resolution referred in below table.
- Do not change any options other than instructed. When modifying camera settings using IPInstaller.
exe - Device web, only setups regarding Video (Thermal Parameter Setup - Offset, Live Screen
Setup, Video Stream Setup) and Network should be modified. Changing other setup might cause
an error.
- When registering the camera to NVR or ISS by Onvif conformance Protocol, the Auto Scan(LAN)
Mode is not supported. Refer to
[QG_DC-TH Series]
for registration.
Model
Thermal Camera Mode
Visual Mode
(Not Thermal Mode)
DC-TH2011
800 x 600, 720 x 540
1280 x 960
DC-TH2012
1920 x 1080, 1280 x 720, 1024 x 768, 640 x 480 2592 x 1944, 2048 x 1536, 1600 x 1200
※
If the resolution is changed from the camera side, the changed resolution is applied in NVR’s
Live image. The changed resolution can be checked by right clicking > Information on the Live
image. However, the NVR’s CAMERA > Stream I > Stream1 resolution does not match
automatically. In this case, there is no problem in use, but if you want to match the resolution,
you can do it manually by changing the resolution in NVR side.’
Summary of Contents for DC-TH Series
Page 2: ......