Part 1 – Introduction
12
•
Check your local laws and regulations on making
video or audio recordings. The user will be held
liable for any violation of the law.
•
When switching over from 12 VDC to PoE as the
power source, the system will be rebooted once the
power adapter is disconnected.
•
Organize the power cable so that it will not cause
people to trip over or become damaged from chairs,
cabinets, desks, and other objects in the vicinity. Do
not run the power cable underneath carpet or a rug
or plug the cable into a power outlet shared by a
number of other devices.
•
Wrap the camera-end of the network cable
twice around the provided ferrite core to subdue
electromagnetic wave generation.
Ferrite Core
LAN Cable
Factory Reset
Only use the factory reset switch to restore the camera
to its factory default settings.
A factory reset will clear all camera settings configured
by the user.
1
Shut off the power supply.
2
Remove the dome cover and then the SD memory
card slot cover.
3
Press and hold the reset switch down
4
Hold the switch down and reconnect the power
adapter.
5
Once the device turns back on, wait 5 seconds, and
then release the reset switch.
6
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
It's also possible to do a factory reset by pressing and
releasing the reset switch while the camera is turned
on or using the IDIS Discovery program from a remote
location. A factory reset will reboot the system. For more
information on factory reset, refer to the
IDIS Discovery
operation manual
.
Lens
Motorized focus and zoom lens
When installing or handling the camera, be careful not
to give an impact on the lens to prevent a malfunction
from occurring.
