Operator Manual
Aspect 100E
L100-3059 REV A
16
BATTERY FUNCTION (Motorized tables)
When AC power is applied, the battery will begin charging until the battery
reaches full capacity. When it does, the charging will taper off. If the power goes
out, the table will automatically switch to battery back-up mode.
An audible tone is sounded when using an operator control function if the battery
charge is low.
• Battery (12V/2.9Ah) Part Number K000-0022 (Replace in pairs)
Battery compartment is part of the control box. Tool required to access batteries:
T20 torx driver.
Local procedures may be in place for proper disposal or recycling.
For more information about batteries, such as battery life, production
codes and
disposal go to the Linak web site for disposal information.
Select “Products|User Manuals” and click on “Actuators & Electronics”.
Linak documentation can be found at their web site:
GENERAL
CLEANING
After each procedure, the table should be carefully cleaned
The disinfectant cleaners and cleaning steps on this page apply to all the parts of the
table, except the lift column.
• Clean tabletop, pads, accessories, and painted surfaces with a clean cloth dampened
with an approved cleaner (see list below).
Do not use abrasives, solvents, sprays, or corrosive agents.
APPROVED AND TESTED DISINFECTANT CLEANERS
•
Sodium hypochlorite (generic household bleach) in solution of 5.25% sodium hypochlorite
diluted between 1:10 and 1:100 with water.
•
Alcohol (generic)
•
Envirocide ®
Disinfectant and Cleaner
