Operator Manual
Aspect 100-4
L100-3316 Rev. A
11
6.
EMERGENCY STOP PUSHBUTTON
➢
The red Emergency Stop Pushbutton is located in the center of the base
cover on the back of the table.
➢
Pressing this button until it is fully engaged will stop all motorized
movement by removing power from all system components.
• ACTIVATE: Engage the emergency stop mode by pressing the button.
• RESET: Restore the electrical functions by rotating the button a quarter turn.
7.
SETUP INSTRUCTIONS & PATIENT PREPARATION
7.1.
Installation
•
Hand operated controls for the movement of the tabletop are included with the table. The
operator should become familiar with the controls before using them.
•
External electrical power connection and disconnection is through the AC power cord and
outlet. The table will operate on 110 V~, 230 V~ or on internal battery backup power. When
external electrical power is applied to the actuators which control the movement of the
tabletop, the green LEDs on the Handset Control will illuminate.
•
The electrical power outlet used should be visible and accessible to the user. The electrical
power cord should be routed where it will not be subject to damage or be a tripping hazard.
•
Check that the ground pin on the electrical cord plug is in good condition before each time
that it is plugged in.
WARNING!
To avoid electric shock, plug the electrical power cord
into a properly grounded hospital grade outlet!
EMERGENCY
STOP
PUSHBUTTON
IMAGING END OF TABLETOP
PEDESTAL END OF TABLETOP
