12
2.3.1.1.3
SAM Control Center Menu Tabs
Entering an OEM/technician password displays the tabs shown on Figure 3. Entering an
OEM/technician password also requires a USB Key be connected to the USB dongle on the rear
of the SAM Control Center. See section 2.6 (page 33) for instructions to use the System Options
button to access the SAM password screens and a list of SAM passwords for an OEM and/or a
technician.
Figure 3.
SAM OEM/Technician Menu Tabs
2.3.1.1.3.1
BAM
Touch the BAM tab (Figure 4) to enter the BAM Menu screen. Touch the Configuration Mode but-
ton to verify a desired devices UID, Manufactures information, Friendly name, and/or CAN ad-
dress. Additional maintenance tasks (Retrieve/Send BAM, Clear/Save List, Clear/Export Data
Log, Send Address Claim, and Reboot (to GUI/Bootloader) are available in Configuration Mode.
Other non-configuration maintenance tasks are also accessible from the HOME MENU screen,
including: Wi-fi settings, touchscreen Master assignment, and real time clock settings. See Sec-
tion 6, SAM Setup/Configuration (page 187) for Configuration Mode detailed information and
procedures.
Figure 4.
BAM Tab
Summary of Contents for Hale Sam
