Idex Hale Sam, Operation Installation Maintenance Manual

Page: 42 / 141

26
4.2.1.3 Discharge Control Area/Section
The discharge control (see Figure 20, page 23), of the Auto Mode main screen allows the pump
operator to select a Quickset, select any discharge, add line (another discharge), and/or change
the pressure a discharge is set to or stop the line (discharge).
To activate a Quickset simply touch the desired Quickset (see paragraph 6.3.1.3, page 71) and
drag it to the discharge target icon (PUSH TO PUMP or ADD LINE).
To select a discharge NOT assigned as a Quickset touch the PUSH TO PUMP (or ADD LINE) icon
to navigate to the SELECT DISCHARGE screen (Figure 26). From the SELECT DISCHARGE screen,
touch the desired discharge button to navigate to that valves control screen (Figure 27).
Figure 26. Select Discharge Screen
Figure 27. Discharge Valve Control Screen
On the discharge valve control screen, to choose the preset pressure (button in the right-hand
side of the screen) simply touch the button and drag it to the target area (SET PRESSURE 0). The
preset is automatically activated, and the Auto Mode main screen is displayed. To set any other
pressure, use the set pressure icon group (refer to paragraph 4.1.1.1, Set Pressure Icon Group)
and confirmation popup buttons (see Figure 4). Touch the NO confirmation popup button to reset
the screen or touch the home button to return to the Auto Mode main screen.
4.2.1.4
Onboard Levels Area/Section
The onboard tank level (or levels if a foam option is installed) is (are) displayed to provide con-
stant visibility for the pump operator. (See Figure 20, page 23). SAM defaults to the onboard wa-
ter tank as the initial water supply and begins pumping from the tank as soon as a discharge is