ideus KZ8000, Manual

Page: 59 / 62

Trouble Shooting
Symptom Cause Solution
No power
The car ignition switch have
not turn on.
If the power supply is connected to
the car accessory circuits, but the
engine is not moving, switch the
ignition key to “ACC”.
The fuse has been blown. Replace a new one.
Presence of CD disc inside
the player. Remove the disc from the player,
and insert a new one.
Disc can not be loaded
or ejected.
Inserting the disc in reverse
direction. Insert the CD with the lab l facing
upward. e
The surface of CD is extremely
dirty or has been scraped. Clean the disc or try to replace
a new one.
Temperature inside the car
is too high. Cool off or until the ambient
temperature return to normal.
Condensation
Leave the player off for an hour or so,
and then try again.
No sound
Volume is in minimum
.
Adjust volume to a desired level
.
The wiring is not properly
connected
.
Check wiring connection
.
Sound skips
The installation angle is
more than 30 . 0
Adjust the installation angle
less than 30
0
.
The surface of CD is extremely
dirty or has been scraped. Clean the disc or try to replace
a new one.
The operation keys
do not work
1. The built-in microcomputer
is not operating properly due to noise.
2. The front panel has not
properly installed.
1. Press the RESET button
to restore the program.
2. Fixed the front panel into
its place.
No radio reception. The antenna cable is not connected.
Insert the antenna cable firmly into
the antenna socket of this CD player.
In automatic search mode
the radio does not stop at
a transmitting station.
The transmission signals are
too weak.
Select a radio station manually.
The following chart will help in solving most problems that may occur. If you still have questions
after going through the checklist, please consult your local customer service representative.
Before going through this check list, refer the wiring and operating procedures.
- Do not warp discs.
- A disc should always be kept in its case
when not in use to prevent from damage.
- Do not place discs in the following places:
1. Direct sunlight.
2. Dirty, dusty and damp areas.
3. Near car heaters.
4. On the seats or dashboard.
Use a dry soft cloth to wipe the surface. If
the disc is quite dirty, Use a soft cloth
slightly moistures with isopropyl (rubbing)
alcohol. Never use solvents such as
benzene, thinner or conventional record
cleaners as they may
the surface
of the disc.
A disc may become somewhat scratched
(although not enough to make it unusable)
depending on the way it is handled and
conditions in the usage environment. Note
these scratches are not an indication of any
problem with the player.
Disc Cleaning
Note:
damage
2. The unit cannot play a CD-R and CD-RW
that is not finalized. (Please refer to the
manual of your CD-R/CD-RW recorder or
CD-R/CD-RW software for more
information on finalization process).
3. Depending on the recording status,
conditions of the disc and the equipment
used for the recording, some CD-Rs/CD-
RWs may not be played on this unit (see *1).
*1: To have more reliable play back,
please see following recommendations:
a. Use CD-RWs with speed 1x to 4x and
write with speed 1x to 2x.
b. Use CD-Rs with speed 1x to 8x and
write with speed 1x to 2x.
c. Do not play a CD-RW which has been
written more than 5 times.
d. The car radio supports discs which
comply with the ISO 9660 level 1 or level 2
format, or the Joliet or Romeo format.
1. When naming a MP3 file, be sure the file
name extension is 'MP3'.
2. For a non-MP3 file, even though the file
name extension is 'MP3', the unit cannot
recognize it.
-
.
- Do not place stickers or make scratches
on discs.
C. Notes on MP3 files
D. Handling and Cleaning
Dirty, dusty, scratched and warped discs
will cause malfunctions
A. Notes on discs:
B. Notes on CD-Rs (recordable CDs)/CD-
RWs (rewritable CDs):
1. Attempting to use non-standard shape
discs (e.g. square, start, and heart) may
damage the unit. Be sure to use round
shape CD discs only for this unit.
2. Do not stick paper or tape, etc, onto the
label side or the recording side of any discs,
as it may cause a malfunction.
1. Be sure to use discs with following marks
only for the unit to play:
Dirty, dusty, scratched and warped discs
will cause a malfunction.
Disc Notes
E Precautions when using new discs
.
A new disc may have irregularities. It will
sometimes be necessary to remove these
rough edges in advance by using a ballpoint
pen or pencil as shown in the illustration.
KZ 8000 17