i-MARKInstallation and Hardware Manual
Page 10 of 22
2.4
Updates
Updates will be provided on request. The information in this document can be changed without prior
notice from IDENTEC SOLUTIONS.
2.5
Scope of Delivery—Visual Inspection
Check delivery whether it is complete and for any damages. If the delivery is not complete or
damaged immediately inform the carrier. The customer service department of IDENTEC SOLUTIONS
should also be informed to facilitate the repair or exchange of the system.
2.6
Associated Documents
System description
•
Reg-No: IM.0721.DE, German, order code:
•
Reg-No: IM.0731.EN, English, order code:
Hardware description and installation manual (this document)
•
Reg-No: IM.0732.DE, German, order code:
•
Reg-No: IM.0732.EN, English, order code:
Firmware description and Programmer’s Guide
•
Reg-No: IM.0733.DE, German, order code:
•
Reg-No: IM.0733.EN, English, order code:
2.7
Bluetooth Module
The Bluetooth module is optional, when installed it enables any Bluetooth device to communicate with
a position marker using the protocol described before via RF.
Note:
The Bluetooth interface only allows communicating with the device itself and does not forward
the messages on the RS422 bus.
2.8
Internal Mains Supply
The compact unit i-MARK 2 is available with an internal power supply to operate at a mains voltage of
230 VAC (Europe).
