Idemia VisionPass, Installation Manual

Page: 14 / 76

14
VisionPass - 2019_2000045728
1.5.3 > Canada (IC) regulatory notices
WARNING TO USERS IN THE CANADA / ATTENTION POUR LES UTILISATEURS AU CANADA
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
This device complies with Industry Canada RF radiation exposure limits set forth for general population.
This device must be installed to provide a separation distance of at least 20cm from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter.
Note : UL LLC has not verified this product for compliance in respect to Canadian standards.
MPH-AC006B product model includes a module compliant with limits set by Industry Canada
o
IC: 2236B-SE3210
This device complies with Industry Canada's RNCs for unlicensed radio devices. Exploitation is permitted
under the following two conditions:
1) The device must not cause interference.
2) The user of the device must accept any radio interference, even if the interference may compromise its
operation.
In accordance with Industry Canada regulations, this radio transmitter may operate with a specific antenna
and maximum gain (or lower) approved for the transmitter by Industry Canada. In order to reduce the risk
of radio interference for other users, The type of antenna and its gain must be chosen so that the equivalent
radiated isotropic power (p.i.r.e.) does not exceed the intensity necessary to establish satisfactory
communication.
This device complies with industry canada's defined levels of RF exposure requirements. The device must
be installed to offer a separation distance of at least 20cm with the user, and should not be installed nearby
or be used in conjunction with another antenna or transmitter.
MPH-AC006B product model incorporates a module that meets Industry Canada's requirement set limits.
o
IC: JQ6-SE3210