13
MorphoWave Compact - 2018_2000035853-v81
1.5.2 > USA (FCC) regulatory notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This device complies with FCC RF radiation exposure limits set forth for general population.
This device must be installed to provide a separation distance of at least 20cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Responsible Party:
Idemia
2, place Samuel de Champlain
92400 Courbevoie
– France
NOTA :
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this unit to ensure compliance with category B FCC restrictions.
MPH-AC007B product model includes a module tested under the FCC rules for a Modular Approval.
FCCID: JQ6-SE3210
MPH-AC007C product model includes 2 modules tested under the FCC rules for a Modular Approval.
FCCID: JQ6-SE3210 and JQ6-XTENDER
NB: the module XTENDER can only be mounted with the module SE3210.
Summary of Contents for MorphoWave SP
