IDEMIA DOCUMENT
– REPRODUCTION AND DISCLOSURE PROHIBITED.
9
External Power Supply:
12-24 Volts (regulated and filtered) 1 Amp min @12V, CEE/EEC EN60950 standard
compliant. A12 Volts power supply compliant with SIA's Wiegand standard will also be suitable. If sharing
power between devices, each unit must receive 1A (e.g. two units would require a 12vDC, 2A supply).
Power Over Ethernet (POE):
power can be provided through RJ-45 connector using
a PSE (Power Sourcing Equipment)
IEEE 802.3af or IEEE802.3at type 1
compliant.
The terminal is a Class 0 (15.4W) PD (Powered Device).
St
ep
tw
o
:
w
iring
PoE Injector Specs
Output Voltage: 48VDC
Output Current: 0.32A
Power: 15.36W
A battery backup or uninterrupted power supply (UPS) with built-in surge protection is recommended.
WARNING: Under powering may cause memory and data corruption; over powering may cause hardware damage.
Both of these situations will void the warranty
Gauge
AWG
Diameter
(mm)
Maximum drop voltage
(V)
at 1m
at 5m
at 10m
20
0.81
0.03
0.17
0.33
22
0.64
0.05
0.26
0.53
24
0.51
0.08
0.42
0.84
IDEMIA recommends using a gauge AWG20 for 12V power supply.
The voltage measured on the product block connector of the terminal
must be equal to 12V-24V (-15% / +10%).
The table at the right, shows the maximum voltage drop between the
power source and the terminal, depending on the length of the cable.
MorphoAccess® VP MD
– Quick User
Guide - 2019_2000041669-V1
Power Wiring
Power supply, Tamper switch & Relay
1
Power +12V
Red
2
Power GND
Black
RJ-45
