12
TP12KSC-DX
July 2018-A
FOUNDATION and ANCHORING REQUIREMENTS
Drill holes using 3/4”
Clean hole.
Run nut down just
Tighten nut with
carbide tipped
below impact section
Torque wrench to
masonry drill bit per
of bolt. Drive anchor
110 ft.-lbs.
ANSI standard
into hole until nut and
B94.12.1977
washer contact base.
2.3 Tools & Equipment Required
•
12 quarts of Non-Detergent / Non-Foaming Hydraulic Oil - SAE-10, AW 32 or equivalent
•
Chalk line and 12’ Tape Measure
•
Concrete hammer drill with 3/4” bit
•
11/16” open end wrench
•
3/4” open end wrench
•
Torque wrench
•
15/16” deep socket or wrench
•
1-1/8” socket
•
13/16” open end wrench
•
Level (18” minimum length)
•
Vise grips
•
Tape measure
•
Funnel
•
Hoist or Forklift (optional)
•
Two 12’ step ladders
•
1/4” drive ratchet with 5/16” socket
3-1/2”
3-1/2”
4-1/2”
4-1/2”
