IDEAL Systemiser SE, Installation And Servicing Manual

Page: 25 / 64

25
Systemiser SE -
Installation
INSTALLATION
32 CONDENSATE DRAIN
31 TERMINAL WALL PLATE
This plate allows neat concealment and full
compression of the rubber seal. Its use is not
essential if the flue hole and flue ducts have been
accurately cut and the outside wall face is flat.
1. Position the terminal wall plate over the
terminal.
2. Drill 4 fixing holes with a 7mm (
1/4
") masonry
drill.
3. Insert the 4 plastic plugs provided.
4. Secure the plate with 4 of the No.10 x 2"
screws provided.
INST
ALLA
TION
The condensate drain provided on the boiler
must be connected to a drainage point,
preferably within the building.
The routing of the drain must be made to allow
a minimum fall of 1 in 20 away from the boiler,
throughout its length.
The drainage pipework must be arranged so
that obstruction (e.g. through freezing) of
external drainage pipe does not give rise to
spillage within the dwelling.
Excessive external pipe runs should be avoided
in order to prevent possible freezing.
All pipework and fittings in the condensate drain
system must be made of plastic. No other
materials may be used.
The drain outlet on the boiler is standard 22mm
overflow pipe. This size must not be reduced in
any part of its length.
In order to defer the onset of freezing of the
condensate drain when the pipe is run
externally the pipe should be run as far as
possible within the building.
The boiler condensate drain connection is
suitable for Bartol 'Polypipe' tubing. An adaptor
is supplied to allow the use of Marley 'Terrain'
tubing, which is slightly larger. This adaptor
should be sealed to the Marley 'Terrain' tubing
and to the boiler condensate drain, using a
suitable plastic tube adhesive.