11
MSC-18K-X
May 2019
It is the user
’s responsibility to provide all wiring for electrical hook-up prior to installation and to
insure that the electrical installation conforms to local building codes. Where required, it is the user
’s
responsibility to provide an electrical isolation switch located in close proximity to the lift that will
enable emergency stop capability and isolate electrical power from the lift for any servicing
requirements.
Tools / Supplies
1. Cutting device to remove packaging.
2. Metric wrenches.
3. Allen wrenches.
4. Philips screw drivers.
5. Clean funnel for adding hydraulic oil.
6. Clean new
*
AW-32 Hydraulic Oil
(Hydraulic Oil needed per column 3.6 Gallons / 13.5 Liters)
*Note: Use only new fresh clean AW-32 Hydraulic Oil.
The use of transmission fluids will void
the lift warranty.
NOTE: MSC-18K-X Lifts are NOT supplied with Batteries.
Customer must supply Batteries as recommended on Page 14.
Installation Instructions
When the lift arrives on site:
Check for any freight damages.
The shipment should be thoroughly inspected as soon as it is
received. The signed bill of lading is acknowledgement by the carrier of receipt in good condition of
shipment covered by our invoice. If any of the goods called for on your bill of lading are shorted or
damaged, do not accept them until the carrier makes a notation on the freight bill of the missing or
damaged goods. Do this for your own protection. Check the contents of the accessory and hardware
boxes to make sure no parts are missing.
NOTE: IT IS DIFFICULT TO COLLECT FOR LOSS OR DAMAGE AFTER YOU HAVE GIVEN THE
CARRIER A CLEAR RECEIPT. THE LIFT MANUFACTURER IS NOT RESPONSIBLE FOR ANY
FREIGHT DAMAGE.
