11
• It takes approximately 1.5 hours to fully charge the battery.
• Once charged, disconnect the cable from the power supply.
• Do not leave the unit plugged in for more than 24 hours.
• To start operation, set the switch (3) to position "1".
USE
• Ensure the razor is clean, properly assembled and oiled (see MAINTENANCE).
• Check the state of charge of the battery - plug in the machine if necessary.
Clipper head
CAUTION. The appliance must not be used to cut wet hair.
• Secure the head (1) in the body (2).
• Start cutting by combing the hair so that it falls naturally.
• Attach the comb attachment (6, 7, 8, 9) - working with the attachment allows you to cut hair from 3-12 mm.
Shorter lengths are achieved by working without the attachment.
• It is recommended to start with the longest length.
• Cut small areas by slowly moving the razor through the hair.
• Start trimming from the nape of the neck upwards or from the forehead and temples upwards.
• Hold the clippers gently under the hair so that the teeth of the attachment point upwards and lie flat on the
head.
• Start the clippers with the switch (3), position "1". The operation of the unit is indicated by the indicator (4).
• After operation, switch off the appliance using the button (3) and clean it.
•
Shaving head
CAUTION. The appliance is not suitable for wet shaving and with shaving gel and foam.
• Fit the shaving head (11) into the body (2).
• Start the appliance with the switch (3).
• Place the head (11) on the skin and move it by pressing lightly.
• When finished working, switch off the device with the switch (3) and clean.
Nose and ear trimmer
• Attach the nose and ear trimmer (10) to the body (2).
• Start the appliance with the switch (3).
• Make sure that the nasal septum and earlobe are clean before use.
• Carefully insert the tip of the trimmer (9) into the nose or ear to a depth of no more than 5 mm and trim only
the hair protruding outside the ear or nose.
• When finished, switch off the appliance with the button (3) and clean.
CLEANING
• Before cleaning, switch the appliance off and disconnect from the mains.
• Do not immerse the appliance or any of its components in water.
• Clean the cutting unit after each use.
• Clean the blades with the brush (12) provided.
•
MAINTENANCE
• Switch off and unplug the appliance before maintenance operations.
• The head (1) requires regular lubrication of the blades to ensure proper and continuous operation.
• After cleaning the head, apply 1 drop of oil (13) to the blade, switch on the appliance to distribute the oil and
then remove excess oil with a cloth.
• Do not use hair oils, grease, oils mixed with paraffin or other solvents.
ENVIRONMENTAL PROTECTION
• The appliance is made of materials which can be recycled.
• It should be handed over to the applicable collection point for the recycling of electrical and electronic
equipment.
