2
classic m -
User's
Introduction
The
classic m
is a wall mounted, room sealed, non
condensing boiler featuring full sequence automatic spark
ignition and fan assisted combustion.
Safety
Current Gas Safety (Installation & Use)
Regulations or rules in force.
In your own interest, and that of safety, it is the law
that this boiler must be installed by a CORGI
registered installer, in accordance with the above
regulations.
It is essential that the instructions in this booklet are
strictly followed, for safe and economical operation of
the boiler.
Electricity Supply
The appliance must be efficiently earthed.
Supply 230 V - 50 Hz. The fusing should be 3A.
Connection must be made in a way that allows complete isolation
of the electrical supply - such as a double pole switch, having a
3mm (1/8") contact separation in both poles, or a plug and socket
serving only the boiler and system controls. The means of
isolation must be accessible to the user after installation.
Important Notes
z
This appliance must not be operated without
the casing correctly fitted and forming an adequate seal.
z
If the boiler is installed in a compartment then the compartment
MUST NOT be used for storage purposes.
z
Under NO circumstances should any of the sealed components
on this appliance be used incorrectly or tampered with.
z
If it is known or suspected that a fault exists on the boiler then it
MUST NOT BE USED until the fault has been corrected by a
CORGI registered installer.
Minimum Clearances
Clearances of
165mm (6 1/2"
) above,
100mm (4"
) below,
5mm
(1/4"
) at the sides and
450mm (17 3/4
") at the front of the boiler
casing must be allowed for servicing.
To light the boiler
(Refer to Frame 1)
1.
CHECK THAT THE ELECTRICITY SUPPLY TO THE BOILER
IS OFF.
2.
Set the mains on/off switch (A) to off and the CH thermostat
knob (C ) to maximum.
3.
Switch on the electricity supply to the boiler and check that all
external controls, e.g. programmer, room thermostat, etc are
on.
4.
Set the mains on/off switch to ON.
The boiler will commence the ignition sequence, supplying heat
to the system when required.
classic m
(Natural Gas Models Only)
classic m3050 ............. G.C. Appliance No. 41- 391- 50
classic m5080 ............. G.C. Appliance No. 41- 391- 51
Destination Countries:
GB, IE
THE LOG BOOK SHOULD BE COMPLETED AFTER
EACH SERVICE AND KEPT WITH THESE
INSTRUCTIONS.
All CORGI Registered Installers carry a CORGI ID card, and have a registration number. Both should be recorded
in your
Benchmark
Log Book. You can check your installer by calling CORGI direct on 0156 372 300.
Summary of Contents for Classic M3050
Page 1: ......
