2,5
1
2
4
3
min. 700
7.2
Installation of Shower kit for A7543AA
Once the shower valve has been securely fitted, work can commence on the installing the shower kit.
Start by assembling the shower rail parts together:
1.
Slide the wall fixing bracket onto the shower
riser rail, orientated as shown. Next slide the
handset bracket onto the riser rail also orienta-
ted as shown. Ensure this bracket is “unlocked”,
rotate the knob to check.
The wall fixing bracket should be posi
-
tioned vertically at lease 700mm away
from the shower valve, as shown here in
this example:
With the wall bracket positioned correctly:
2
. Using a 2.5mm hexagonal key, tighten
the two grub screws visible from the rear
of the wall bracket. This will secure the
wall bracket to the riser rail
3.
This assembly of the shower rail
parts together, can now be located
onto the nipple on the top surface
of the shower valve as shown. Be
careful to hold this assembly in place,
otherwise it will topple over & get
damaged.
Take care not to damage the O-ring
fitted to the nipple during assembly.
4.
Use a spirit level to ensure the
shower riser rail is vertical.
Note: the mixer supplied with A7543AA is fitted with
an additional outlet nipple on the top surface to
connect the over head shower plate.
Smear a small amount of approved silicone grease
onto the O-ring fitted on the nipple. This will help to
prevent damage to the O-ring during assembly.
Use a WRAS approved silicone grease
(eg: Klueber Unisilkon L250L).
12
