Page 9 of 17 5/11/2012
MODEL 6616 Wireless Outdoor Adjustable Angle Motion Detector Sensor
INSTALLATION
Install 3 AAA batteries included into the bottom of the motion detector as shown below.
This sensor is already learned to zone 1. If you wish to change the zone location of this
sensor follow the directions at the end of these instructions.
To Learn Wireless Sensors or
Remote Control Codes
. Once motion detector is triggered zone 1 will flash on the screen.
The detection range (left to right) can be adjusted from 150 degrees to 0 degrees by sliding
the two sliders on each side of the motion detector. You can also adjust the sensitivity from
10m to 3m range by turning the dial located on the bottom of the unit under the battery
cover. Note: If range and sensitivity is set too high it could result in false triggers. Test the
area requiring coverage to make sure you do not get false triggers due to an excessive range
field.
Detection range left to right
Sensitivity
Mounting the motion detector:
Choose a suitable location, 5~6 feet (1.5~2.0 meters) above the floor. Using template
included drill holes and fasten with anchors and screws provided.
BATTERY LOW INDICATOR
When batteries are low, the LED will flash on 3 seconds and off 1 second. Replace the
batteries immediately, to maintain proper detection. If batteries are low they may send a
Install
batteries
included
Install
batteries
included
Install
batteries
included
