Page 8 of 17 5/11/2012
The auto-dialer has been factory pre-set for auto dialing for 1 cycle (When a sensor is
triggered the auto dialer will call all stored numbers 1 time. You can change this cycle from
1 to 5 dialing cycles.
a.
Enter password followed by
PROG
button six (6) times.
b.
CYCLE will flash on the auto-dialer screen.
c.
Press
ARM/DISARM
button to confirm.
d.
Using
*/UP
and
#/DOWN
buttons to select cycle times between 1 and 5
followed by the
ARM/DISARM
button to confirm.
e.
Press
PROG
button four (4) times to exit set up mode.
9. TO PROGRAM CALL-IN RING DETECT CYCLE (how many rings before auto
dialer will answer.
The auto dialer has been factory preset to answer on the 5
th
ring.
The call-in ring detect cycle is for how many times you want the phone to ring before the
auto-dialer picks up. You can arm/disarm and monitor your home via the telephone.
a.
Enter the password followed by the
PROG
button seven (7) times.
b.
A
will flash on the screen.
c.
Press
ARM/DISARM
button to confirm.
d.
Using the
*/UP
and
#/DOWN
buttons select 3, 5, 7 or 10 (which
represents the # of rings before the auto dialer picks up) followed by the
ARM/DISARM
button to confirm.
e.
Press the
PROG
button three (3) times to exit set-up mode.
NOTE:
You cannot use an answering machine with this feature. If you want to be able to
call in to the auto dialer you must program it to answer before your answering machine
does. Example if your answering machine answers after 4 rings, you must set the auto
dialer to answer at 3 rings.
10. TO PROGRAM ENTRY DELAY TIME: (Amount of time you need to deactivate
system once you have entered your residence)
a.
Enter password followed by
PROG
button eight (8) times.
b.
ENTRY will flash on the auto-dialer screen.
c.
Press the
ARM/DISARM
button to confirm.
d.
Using the
*/UP
and
#/DOWN
buttons select the seconds 0,5,10,15 or 20.
Press
ARM/DISARM
to confirm the number of seconds you require for the
entry delay time.
e.
Press the
PROG
button twice (2) to exit set-up mode.
TO TEST MEMORY DIALLING
In standby mode, press and hold the
PROG
button for at least 3 seconds, you
will hear a short beep. Key in the memory location of the telephone number, i.e. 1 – 5. The
telephone number stored in specified
memory location
will automatically be dialed. Press
the
PROG
button to stop the dialing. The auto dialer must be connected to a land line
in order for this function to work. If not connected then you will hear 4 short beeps.
