28
Concord CXD -
Installation
41 BURNER AND CONTROLS ASSEMBLY - Exploded View - CXD 70-100
LEGEND
1.
Main gas inlet cock.
2.
Gas inlet union.
3.
'O' ring seal.
4.
Gas control valve, Low.
5.
Gas control valve, High.
6.
Spark generator.
7.
Burner manifold.
8.
Main injector, 3 off.
9.
Main (centre/RH) burner, 2 off.
10.
Main (LH) burner, 1 off.
11.
Ignition electrodes.
12.
Overheat thermostat mounting bracket.
13.
Overheat thermostat.
14.
Detection electrode assembly.
15.
Gas pipe.
16.
Gas restrictor
PTP
Pressure test point
SERVICING
SER
VICING
42 OVERHEAT THERMOSTAT
1. Undo the 2 screws retaining the overheat thermostat
assembly and withdraw the assembly.
2. Undo the 2 screws securing the thermostat cover to the
support bracket and withdraw the thermostat from the
cover.
3. Remove the push on tags from the thermostat body noting
their positions.
4. Trace the thermostat capillary to the thermostat pocket
remove the split pin from the thermostat pocket and lift out
the thermostat phial.
5. Undo the single nut securing the thermostat to the bracket.
6. Fit the new thermostat in reverse order (ensuring that the
capillary is located in the notch provided in the support
bracket). Reconnect the push on tags to terminals 1, 2 and
on the overheat thermostat body.
Ensure that the phial is secured with the split pin in the pocket
on the rear section and the capillary is rerouted along the side
casing in the clips provided.
Summary of Contents for Concord CXD 40-100
Page 1: ......
