www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
install guide
Version française disponible en ligne au www.idatalink.com
transponder Bypass
General motors
Page 5 of 6
ADS-TBSL-GM
20071220
www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
NOTICE:
the manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. this device must be installed by a certified technician. this guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. please review the installation guide carefully before beginning any work.
1
2
Insert the vehicle key into the ignition.
Turn the ignition to the “ON” position and
START THE VEHICLE
.
Wait for the LED to illuminate green
for
2 SECONDS
.
Programming is complete.
VEHICLE PROGRAMMING
ON
LED “ON” 2 SEC
1
2
NOTE
MODE SELECTION
1X
2X
PRESS
TO TOGGLE
BETWEEN MODES
PRESS + HOLD
Should you wish to change the installation mode,
follow the “Factory Reset” instructions as detailed below.
Press and release the programming button to select installation mode.
To register selection,
Hold the programming button down
until the LED displays a solid green light
.
OR
IDATALINK MODE
STANDARD MODE
LED flashes once
LED flashes twice
REMOTE STARTER
with Data Port
REMOTE STARTER
without Data Port
ProGramminG Procedure
3. proGram your module
see instructions below
Doc. No.: ##00160##