1
2
Insert the vehicle key into the ignition.
Turn the ignition to the “ON” position.
Wait for the LED to illuminate GREEN
for 2 SECONDS.
Programming is complete.
ON
LED “ON” 2 SEC
MODULE PrOgrAMMing
XX-XX
PAGE X-X
ADS-AL(DL)-CH6
PAGE X-X
inSTALLATiOn MODE SELECTiOn
1
PRESS AND RELEASE
programming button
to
select installation mode
.
OR
Remote Starter
Standard Mode
LED fl ashes twice
x2
Remote Starter
Data Mode
LED fl ashes once
x1
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
2
PRESS AND HOLD
programming button
until LED turns solid GREEN
to
register selection
.
5
Turn key to OFF position.
MODULE PrOgrAMMing PrOCEDUrE
7
Module Programming
Procedure completed.
OFF
1
Insert key into ignition.
2
Turn key to ON position.
ON
4
Wait, it may take up to
20 seconds
. LED will turn solid
GREEN then will turn OFF.
3
LED will turn solid RED.
6
Remove key.
ADS-AL(DL)-CH6
98
ADS-DL-CH6 98
ADS-TB-CH6 98
ADS-AL(DL)-CH6
98
ADS-AL(TB)-CH6
98
ADS-DL-CH6 98
ADS-TB-CH6 98
Page 11 of 12
ADS-DL-CH6
20100810
install guide
guides Français disponibles au www.idatalink.com
www.idatalink.com/support
automotive data solutions inc. © 2010
Doorlock Interface
Chrysler/DoDge/Jeep
Doc. No.: ##3737##
