Using the 1/4” hex key
wrench, disassemble the pole
mount then re-assemble the
INSTALLATION INSTRUCTIONS
WALL
MOUNT
DESK
MOUNT
POLE
MOUNT
Locate the stud and mark the top hole, drill 11/64 pilot
hole and insert #14 screw and tighten slightly. Using a level,
mark the two lower holes and drill pilot hole, insert the last
two #14 screws again making sure the unit is level.
NOTE
Drill a 3/8 hole through the horizontal surface and
insert 3/8 set screw provided. If your desk mount
doesn’t have a riser tube, place the desk pad
provided under the desk puck Attach washer and
lock nut on the lower side of surface you are
mounting to. If you are mounting to a thicker or
thinner surface, the set screw provided can be
replaced with standard 3/8 bolt.
Locate the wall stud and mark the top hole of the
Wall Track, drill 11/64 pilot hole and insert #14 screw
and tighten slightly. Use a level, mark the lower holes,
drill pilot holes and then insert the #14 screws, again
making sure the unit is level. Remove small socket head
cap screw in the top middle of the Wall Track. Insert the
Slider into the Wall Track as shown right and replace
the small socket head cap screw.
NOTE 1:
If your LCD
is over 17” in width mount the LCD under the arm
assembly simply by turning the Slider upside down and
insert into the Wall Track.
You cannot mount the LCD
under the arm assembly if the Keyboard option
is used.
NOTE 2:
ICW supplies # 14 Wood screws. If
installing into metal studs, you will need to replace these
with proper metal stud fasteners.
TRACK
SLIDER
Installation instructions for the Ultra 210 series.
II010 Revision C. 9-12-03 MF
Products names, photo’s, and drawings contained in this document are Copyright
©
2003 ICWUSA.com, Inc.
pole mount around the pole at the height
desired.
NOTE 1:
If your LCD is over 17” in
width mount the LCD under the arm
assembly simply by turning the unit upside
down and attaching it to the pole.
You
cannot mount the LCD under the arm
assembly if the Keyboard option is
used.
1:
ICW supplies # 14 Wood
screws, if installing onto
metal studs, you will need to
replace with proper metal
stud fasteners.
NOTE 2:
If
your LCD is over 17” in width mount the LCD under the
arm with the wall plate inverted or up side down.
You
cannot mount the LCD under the arm assembly if
the Keyboard option is used.
