TITAN ELITE CEILING & WALL MOUNT INsTALL
TITAN ELITE INSTALLATION - 09/01/16 pjm
Page 3 of 4
Attach QuickLink & Monitor
Cord Management - Wall Mount
REMOVE ELITE ARM COVERs
END COVERs
Remove the end covers by
unscrewing the two 3/4” long
10-24 flathead screws using a
Phillips head screwdriver.
TOP COVER
Remove the long arm cover
by unscrewing the two 1/4”
long 6-32 flathead screws in
the center of the cover using
a Phillips head screwdriver. If
you use a power tool, be very
careful not to strip the screws.
The arm needs to be in a
vertical position to remove the
long top cover.
MANAGE CORDs THROUGH ARM - WALL MOUNT
Feed monitor and other cords and any other cords down
through opening in wall mount. Slip all cords through Titan
arm, out through end cap and into the back of the Elite arm.
When running cords through arm, keep them all to one side
of bolts at Titan arm joints. Pass cords through holes in Elite
arm end covers. Reassemble arm and reattach covers.
NOTE: When measuring for length of cords, be sure
to allow enough extra cord to accommodate tilt and
rotation of monitor.
note: CorDS CAn Be DAMAGeD IF JoIntS Are
rotAteD More tHAn 360 DeGreeS. USe rotAtIon
StoP PInS to AvoID DAMAGe.
Rotation
bearing
Rotation
bearing
End cap
End cover
End cover
Top cover
Titan Arm
Wire Management Detail
ADJUsT QUICkLINk TILT
QuickLink
buttons
Pivots
Use the under-monitor handle
to rotate, tilt and swivel the
monitor to desired position.
Increase range of motion by
depressing buttons on back
of QuickLink. Each button
provides 90° of adjustment
for its corresponding pivot.
Depressing both buttons
at once provides 180° of
adjustment.
ATTACH QUICkLINk TO ARM
9/16 wrench
Nut
Remove nut from bolt
on QuickLink. Attach
QuickLink to arm. Thread
nut onto bolt through front
of arm assembly. Tighten
bolt with provided 9/16”
wrench.
ATTACH VEsA AND HANDLE TO MONITOR
Using a Phillips
screw driver, attach
the VESA plate
to the back of the
monitor using four
4mm screws in the
hardware bag.
Attach handle to
VESA plate.
