Configuring the Inovonics EchoStream Select Jumper
This section applies only to the European variant of the Inovonics receiver module (PRT-IVO-IF-EU).
If you are using Inovonics EchoStream Select products in your system, you need to enable EchoStream Select
compatibility on this device using the ES jumper.
The jumper is labeled
ES
and is located on the Inovonics side of the board:
N+
N-
NA
NB
NC
CO
MN
O
NZ AUS
EchoStream
Select Jumper
ES
AUS
ES
To enable EchoStream Select compatibility, place the jumper over the ES pins:
ES
If there are no EchoStream Select products being used in your system, remove the jumper from the ES pins.
If the device is powered on, remove and restore the power source to apply the change.
PRT-IVO-IF | Protege Inovonics Wireless Receiver Module | Installation Manual
11
