XMC-A825-16 ARINC-825 16 Channel XMC / CANFlight-16 User's Manual REV C
Document: TP2216-901_Users_Manual.pdf
Page 11 of 39
© Innovative Control Systems
Project:
TP2216-901
Author: K. Jacobson Date: 11.05.2019
Rev.: C
3.1 Gigabit Ethernet Connection
The XMC-A825-16 ETHERNET Connector has a pinout according to the established RJ-45 standard as
shown in Figure Illustration. This connector also contains two Status LEDS which indicate the negotiated
Ethernet data rate and interface transmit activity.
This connector is only used when the on-board Intel Gigabit Ethernet Controller is not enabled. To use this
interface, the option PCI=0 must be set in the configuration file “XMC_A825.CFG” on the micro SD card
installed. See the Section entitled XMC-A825-16 Configuration
Figure 3-2 Gigabit Ethernet Connector layout
Table shows the corresponding Ethernet signal assignment for the RJ-45 connector.
Pin
Signal Name
Signal Description
1
TX+
Transmit Data +
2
TX-
Transmit Data -
3
RX+
Receive Data +
4
N.C.
Not Connected
5
N.C.
Not Connected
6
RX-
Receive Data -
7
N.C.
Not Connected
8
N.C.
Not Connected
Table 2: RJ-45 Connector Signal Definition
1 2 3 4 5 6 7 8
Speed LED
Green: 100 Mbit/s
Tx modulates
Speed LED
Amber: 1 Gig bit/s
Tx modulates