Tunnel Master® wbc Installation Guide
Page 12
Tunnel Master® wbc Installation Guide
Page 12
ID
Terminal Block
Input Name
Description
2
Assigned Function Inputs
GATE (SIGNAL)
General note: ICS highly recommends
Using shielded cable for all input wiring.
Terminate the shield drain as close to the
24 V AC power supply as possible.
TIRE (SWITCH)
ROLLER LOCATOR
REMOTE ROLLER
EM TIRE2
(ENTRANCE MGMT)
ANTI-COLLISION
INPUT 1 (DELAYED
PANIC)
3
Expansion
INPUT2–9
Reserved for future ICS use.
Delayed Panic Input
The Delayed Panic Input, if active, will pause the conveyor for the programmed amount of time before
entering a full Panic Stop Node.
Recommended:
purchase either a yellow or orange push/pull stop button.
The Delayed Panic Input is located on the Main CPU board as Input 1.
Input Board Components
Delayed Panic Input
Figure 5. Delayed Panic Input
Table 6. CPU Board Terminal Blocks
