13
9. MAINTENANCE, CHECKING AND CLEANING
9.1. Changing batteries
•
Turn the display OFF
•
Unscrew de fixation screws of the handle and extract the battery compartment block.
•
Pull out the batteries cover with the string attached to it.
•
Replace the 3 batteries and respect polarities (leave the fake cell in place)
•
Place back the battery compartment and screw back the handle
Take care to replace the handle correctly : the positioning mark of the handle must
match the one on the main body.
9.2. Regulatory check
New appliances come with a certificate of adjustment. This document indicates the values
obtained during adjustment and certifies that the sensor has been adjusted, in compliance with
an in-house procedure, on a calibration bench with its calibration sensor connected to the
International Standard calibrator.
Tractel
®
recommends an annual metrological check for every appliance.
9.3. Maintenance
The sensor/display unit requires no specific maintenance other than a regular cleaning with a
dry cloth.
10. MESSAGES
10.1.
Information messages
Message
Cause
Solution
----------
No wire rope selected.
Select a wire rope ( § 6)
- MIN -
Current effort is below the measurement range of the
selected wire rope.
Apply tension in the wire
rope.
- MAX -
Current effort is above the measurement range of the
selected wire rope.
Lower the tension in the
wire rope.
!!!!
Current effort is way above the measurement range of
the selected wire rope.
Lower the tension in the
wire rope.
Auto Off : xx
S
Announcement of the imminent extinction of the device.
Press key "T" to reset the
counter.
TIME
Automatic extinction of the device.
BAT
Automatic extinction of the device due to low batteries
condition.
Replace the alkaline cells
(see § 9.1)
