![background image](http://html1.mh-extra.com/html/ics/epx-20/epx-20_operation-manual_3529618004.webp)
Set the unlocking time
Enter the setting mode:
Press
*1
(mode indicator flashes yellow),then press the number from
00
to
99
(a short tone will be
heard to indicate success).
05 = 5 seconds
10 = 10 seconds
Press # button to exit the setting mode.
Deleting All Prox Cards/Tokens And User Codes
Enter the setting mode:
Press
*8
(mode indicator will start to flash yellow), then press
88
(a short tone will be heard).
Press # to exit setting mode.
All prox cards/tokens and user codes have now been deleted.
Restore To Factory Settings
Press
*8
(mode indicator will flash yellow),then press
99
(a short tone will be heard)
Press # button twice to exit the setting mode.
Attention
:-This operation deletes all prox cards/tokens and user codes it will also reset the master
code to 4 digits 1234.
If the master code is not known:-
Power down the keypad for approximately 10 secs.
Reconnect the power.
While the mode indicator is flashing red press and hold the # for 5 secs (a short tone will be
heard).
The keypad is now reset to factory settings.
Attention
:-This operation deletes all prox cards/tokens and user codes it will also reset the master
code to 4 digits 1234.
Change Master Code
Enter the setting mode:
Press
*3
(the mode indicator will start to flash), then input the new master
code twice
(the length
of new admin code should be the same as the old one).
Two short tones and the mode indicator will stop flashing, this indicates the change was
successful.
Press # button twice to exit the setting mode.