Setting The Length Of The Master Code
Enter the setting mode:
Press buttons
* 9
(mode indicator starts to flash), then press
04
(a tone will be heard and the mode
indicator stops flashing), then input :-
2
(for 2 digit operation)
3
(for 3 digit operation)
4
(for 4 digit operation)
5
(for 5 digit operation)
6
(for 6 digit operation)
A single tone is then heard to indicate the length of the master code has been successfully
changed.
If 3 single tones are heard the code length is the same as the existing code length.
Press button # to exit the setting mode.
Attention
: When the length of the master code is changed all existing cards/tokens and user codes
will be
deleted
.
Adding User Codes
Enter the setting mode:
Press
*9
(the yellow mode indicator will start to flash), then press
02
(a short tone will be heard
and mode indicator will stop flashing), then enter the location slot
000
to
999
(each user code must
be allocated its own user slot).Then enter the new user code ( the length of the user code must be
the same as the master code)
Press the # key to exit setting mode.
Adding User Cards/Tokens Only
Set the access Mode to Prox only.
Enter setting mode:
Allocate a location slot
000-999
(each card/token must have its own location slot)
Then show the prox card/token to the keypad.
Press the # key to exit setting mode. .
Adding User Cards/Tokens and User Codes
Enter the setting mode:
Allocate a location slot
000-999
:
If the mode indicator turns red the location slot has already been used, to delete this press * twice
and the location slot will be cleared and the mode indicator will turn green.
Once the mode indicator light is green show a proximity card/token.
Input a user code (must be the same length as the master code)
A short tone will be heard the mode indicator will stop flashing green and turn yellow, this
indicates the operation was successful.
2.If green light bright means no record on that number before and can add the passwords in.
Press # button to exit the setting mode.
