ICS Auto Passport, Installation Manual

Page: 12 / 14

Auto Passport Installation Guide Page 11
Copyright © Innovative Control Systems, Inc.
RFID All-In-One Reader/Antenna Wiring
1. Unplug the cables from the bill dispenser.
2. Unbolt the bill dispenser from the bill dispenser tray.
3. Remove the bill dispenser.
4. Unscrew any cable clamps holding the bill dispenser cables to the drawer and remove the cables from the drawer.
5. Remove the bill dispenser drawer from the base of the Auto Sentry flex .
6. Using the fish tape, pull the RFID All-In-One Cable through the 1” conduit from the base of the truss to the Auto Sentry flex .
7. Locate the set of terminal blocks included on the left wall inside the base as shown in Figure 13.
NOTE:
There is a terminal description label below the terminal blocks.
8. The RFID All-In-One RFID Reader/Antenna cable has 5 wires to connect to the terminal blocks as follows, see Figure 13 and
Figure 14.
„ Attach the power wires marked 24VDC(+) and 24VDC(-) from the RFID reader to the bottom terminals of the orange
and black terminal blocks: 24V DC(+) wire to orange terminal block 24V DC(+), and the 24V DC(-) wire to black terminal
block 24V DC(-).
„
Attach the data wires from the RFID reader to the bottom terminals of the orange, yellow, and white terminal blocks:
the wire marked (Tx) to the orange terminal block (Tx), the wire marked (Rx) to the yellow terminal block (Rx), and the
wire marked Ground to the white terminal block (GD).
9. Re-install the bill dispenser drawer and the bill dispenser.
10. Re-attach the cables for the bill dispenser.
Figure 13. Terminal Block Inside Auto Sentry Base Figure 14. Wire Termination