NAV6 Series NAVTEX System User Guide
38
Connecting the Display Unit to the Receiver Unit
The display cable consists of six twisted pairs. These should be connected to the
corresponding terminals on the NAV6 receiver module as shown below:
Twisted Pair
Core Colour
Signal description
RED twisted with BLACK
RED
16
V+ (12V)
BLACK
15
V- (GND)
BLUE twisted with BLACK
BLUE
10
NOT USED (can be used as NMEA A input if
display is being used as an instrument
repeater only)
BLACK
11
NOT USED (can be used as NMEA B input if
display is being used as an instrument
repeater only)
BROWN twisted with BLACK
BROWN
12
PRN Tx
BLACK
NOT USED
WHITE twisted with BLACK
BLACK
3
DISP B
WHITE
4
DISP A
YELLOW twisted with BLACK
YELLOW
NOT USED (Aux V+ Ensure this cannot
short)
BLACK
NOT USED
GREEN twisted with BLACK
GREEN
NOT USED
BLACK
NOT USED
Screen
Silver
15
Nominally 0V
The diagram on the next page shows the wiring for a typical NAV6 system.
Note: The PRN Tx and PRN GND are termination positions only and are not used internally by
the receiver.
Note: The blue and black wire pair from the Display Unit is not used with the eNAVTEX V3
Receiver but can be used as NMEA A and NMEA B inputs respectively if the Display Unit is being
used as an instrument repeater only.
Note: The eNAVTEX V3 Receiver has an internal termination link fitted as standard between
terminals 4 and 5. This must be fitted for all single display system configurations. An optional
external link can be fitted as shown. The internal link must be removed if two displays are to be
connected.
