NAV6 eNAVTEX System Installation & Quick Start Guide
13
Fuses
The NAV6 eNAVTEX receiver has built-in resettable fuses on the 12V inputs. This fuse will trip
if the unit due to a fault condition draws excessive currents. Power must be disconnected from
the unit for 10 seconds in order for a fuse to reset.
Specification
Receiver Module
Power Consumption (typical)
90mA at 12V
Antenna input
50ohm
Weight
200g
Physical Dimensions
Height: 96mm (excluding connector)
Width: 146mm
Depth: 35mm
Mounting
Bulkhead mounting via four self-tapping screws (supplied)
Connection
All connections made by screw terminal (with the exception of the PC USB connection)
Environmental
Not for outside use
Unit must be mounted below decks in a suitable dry location
Receive Frequency
490kHz and 518kHz
Antenna- Passive
Length
0.5m (1.5ft)
Weight
1kg
Bottom Diameter
28mm
Fittings
1”-14 threads female
Structure
Epoxy Fibreglass
Ferrule
Chrome Plated Brass
Base Torsion Force 5N at max Wind Speed
Frequency
490-518kHz
Impedance
50 ohm
Gain
-3db half wave dipole
Polarization
Vertical
Lighting Protection DC Ground
