ICRealtime N6 CIF Series, Quick Start Manual

Page: 14 / 37

10
Figure 1-6
You can refer to the following sheet and Figure 1-6 for alarm input and output information.
1
，
2
，
3
，
4
，
5
，
6
，
7
，
8
，
9
，
10
，
11
，
12
，
13
，
14
，
15
，
16
ALARM 1 to ALARM 16. The alarm becomes active in low voltage.
NO1 C1
，
NO2 C2
，
NO3 C3
，
There are three groups of normal open activation output (on/off
button)
Earth cable.
485 A/B 485 communication port. They are used to control devices such as
PTZ. Please parallel connect 120T
Ω between A/B cables if there are
too many PTZ decoders.
1.8.1.1 2U Series
The 2U series product interface is shown as in Figure 1-7.
Figure 1-7
You can refer to the following sheet and
Figure 1-7
for alarm input and output information.
1
，
2
，
3
，
4,, 5, 6, 7,
8, 9, 10, 11, 12, 13,
14, 15, 16
ALARM 1 to ALARM 16. The alarm becomes active in low voltage.
NO1 C1
，
NO2 C2
，
NO3 C3
，
NO4 C4,
NO5 C5 NC5
The first four are four groups of normal open activation output
(on/off button)
NO5 C5 NC5 is a group of NO/NC activation output (on/off button)
CTRL 12V Control power output. You need to close the device power to ca ncel
the alarm.
+12V It is external power input. Need the peripheral equipment to provide
+12V power (below 1A).
Earth cable.
T+, T-, R+, R- Four-wire full-duplex RS485 port.
T+, T- is the output cable and R+, R- is the input cable.
AB cable
connection