Mobile DVR Installation Instruction Guide
5
1
Preparation
1.1
General Installation Process
Before installation, you need to know the installation includes the following steps:
z
You need to select the installation plan and installation technique according to your vehicle type.
z
You need to properly arrange the schedule for the vehicle to be installed.
z
Write down the vehicle plate number and its corresponding device number.
z
Select the installation position and complete the preparation works (dig holes, dismantle and etc.).
z
Lay down the cable.
z
DVR cable connection
z
DVR installation
z
Whole system debug and test.
1.2
Installation Plan
The installation engineer and the people from vehicle technical department shall work together to draw out
the installation plan and techniques. The both sides shall select the instillation vehicle together and the
on-site engineer is responsible to get the device and accessory, check the quality and upgrade the mobile
DVR software. During the installation process, the installation group is responsible to record the device
corresponding code, technique check, cable connection and system debug.
1.3
Installation Tools
The mobile DVR installation tool list is shown as below:
z
Phillips
screwdriver
z
Bent
strippers
z
Wire
strippers
z
Needle nose pliers
z
Adjustable
wrenches
z
Electronic runner (Dry cell runner is preferred.)
z
Multimeter
z
LCD for debug
z
A 2-meter steel cable (diameter 1.5mm.) to cable layout
z
3.2mm and 4.5mm aiguille
1.4
Installation Material
1.4.1 Cable
Cable is used to connect the power and the vehicle signal. For cable connected to the power, please use
1.0 square meter or higher 3-pin cable. For cable connect the vehicle signal, please use 0.25 square
meter or higher 2-pin or 3-pin cable (including shielded layer).
1.4.2 Screw