6
2
Device Installation
2.1
Installation Steps
Figure 2-1
Important
Before the installation, please make sure the installation surface can at least support 3x weight
of the camera and the bracket.
Please follow the steps listed below to install the device. Please refer to Figure 2-1 for reference.
Step 1
Use star-shaped wrench in the accessories bag to unscrew the three star-shaped screws on the dome
enclosure, and then open the dome enclosure.
Step 2
Please take out the installation position map in the accessories bag, and then paste it on the ceiling or
the wall according to your monitor area requirements.
Step 3
Find “cross” signs on the map, and dig three plastic expansion bolts holes on the installation surface
and then insert three expansion bolts into the holes. Secure these three bolts firmly.
Step 4
Adjust the device installation pedestal to the proper position and then pull cable through the exit hole
on the installation surface. Line up the three screw holes in the device pedestal to the three plastic
expansion bolt holes in the installation position. Put the three installation screws into the three plastic
expansion bolts and secure them firmly. Fix the pedestal on the installation surface.
