16
Linking the Remote Controller and Receiver
The receiver is mounted near the Development Board Type A of Robot's chassis (as shown below).
The remote controller is linked to the DR16 receiver by default . Follow these steps to link the remote
controller with the receiver:
1.
Link Hole
1.
Locate the Link Hole on the right of the Development Board Type A on the chassis, within which
there is the Link Button of the receiver.
2.
Power on Robot and ensure that the receiver is powered up. If there are no other powered-on
controllers nearby, the Power LED Indicator of the receiver is solid red.
3.
Power on the remote controller and bring it close to the receiver until the Power LED Indicator of
the receiver blinks green.
4.
Press and hold the Link Button for two seconds. The Power LED Indicator of the receiver blinks
red during linking.
5.
Release the Link Button. The Power LED Indicator of the receiver displays solid green once the
remote controller successfully links to the receiver.
Ensure the remote controller is close to the receiver and there are no other powered-on
remote controller nearby during linking.
For the communication protocol between the DT47 remote controller and the DR16 receiver, please
refer to the RoboMaster Robot Remote Controller (Receiver) User Manual in the Information Kit.
