Industrial Ethernet Layer 2 Managed Switch – Web Management Manual
April 29, 2008
16
Email Setting
User can select “Disable Alarm Mail” to stop the email alarm sending (factory default).
If email alarm is enabled, there are two methods of email report for you select.
The first one is: warning mail is sent immediately when events occur.
The second is: user can specify the interval time between 1 to 99 hour(s), and system will
sending the system report by email every the specified hour(s).
Before active email sending, you have to finish following settings.
Mail Server IP
IP address of mail server
Sender
Specify the email address of sender.
Receiver.
Specify the email address that you wish to notify.
After finishing and activating above setting, the “Send Test Mail” button will show up. You can
click the button to check if the settings are correct.
NOTE!!
Please be sure the MASK and GATEWAY are properly configured. Otherwise, it may cause
the email sending fault.
