98
The
button turns red for 3 seconds to indicate that the Exit Delay has started (twice as long as the
period configured for Arm Away—up to 120 seconds with no beeping from the TouchScreen). If the
system is not ready (because, for example, a door or window is opened) the button flashes orange seven
times.
Disarming the System
Enter a valid keypad code followed by the
button to disarm the system.
The
button turns green for 3 seconds to indicate that the system has been disarmed. There is no
Entry Delay period.
Sending an Emergency Police Alarm
Press and hold the shield and asterisk button for 2.5 seconds to send an audible panic alarm to the
central monitoring station for police assistance.
The LED flashes red to indicate that the alarm has been sent. Additionally, contact persons will receive
email and SMS notifications if they are configured to do so.
Mounting the Key Pad
To mount a key pad to the wall:
1. Use a Phillips screwdriver to remove the faceplate from the front of the
key pad (
).
Behind the circuit board, four holes are visible at the back of the device.
Figure 19: Remove the
faceplate
2. Place the key pad on the wall where you want it located and use a pen to mark the location of the
four holes.
3. Install four screws in the locations marked on the wall. Do not screw them in all the way.
4. Affix the key pad to the installed screws.
5. Replace the faceplate to the front of the key pad.
TouchScreen User Guide
