Iconic 1100 Bay, Installation, Servicing And User Instructions Manual

Page: 14 / 48

IE & GB
14
2.6 To Ignite the appliance
Note - If this appliance is extinguished or goes out in use for any reason, wait 3 minutes before attempting
to relight the appliance. The Gas Control Valve has an interlock device which will not allow relighting until
the 3 minutes have passed.
To be able to use the Remote control Handset (fig. 1.1), the rocker switch on the Gas Valve, must be turned
"ON" (the "1" position) and the manual Dial set to the "On" position.
- Simultaneously press and hold buttons B & C (Star and Large Flame), until a short acoustic beep confirms
the start sequence has begun; release the buttons.
- Continuing signals confirm the ignition is in process.
- Once pilot ignition is confirmed, there will be gas flow and the main burner will ignite.
- Repeat process if pilot ignition fails.
2.7 To Turn the appliance OFF
Press the OFF button (Button B fig. 1.1) on the Handset. This will extinguish all Burners including Pilot.
Note: - Repeated presses of the small flame (Button D fig. 1.1) will turn the main burner OFF, but will leave the
Pilot alight.
2.8 Adjusting the Flame setting
To increase the flame height; press the large flame button (Button C fig. 1.1).
To decrease the flame height; press the small flame button (Button D fig. 1.1).
2.9 Using the "Effect" Burner
Note: The solenoid valve will not operate for one minute after Ignition.
The solenoid valve cannot be operated manually. If the battery runs down, the solenoid will remain in its
last operating position.
During normal operation the solenoid will be reset to the ON (Open) when the Gas Valve is switched OFF
via the Handset.
Upon ignition both "Main" and "Effect" burner are ON.
To switch the "Effect" burner OFF, simultaneously press the OFF and Large Flame buttons (buttons B & C fig.
1.1).
To switch the "Effect" burner ON, simultaneously press the SET and Large Flame buttons (buttons A & C fig. 1.1).
Printed instructions are located on the battery cover on the rear of the handset.
2.10 Setting °C/24 hour or °F/12 hour clock
Simultaneously press OFF and Small Flame buttons (buttons B & D fig. 1.1) until display changes from
Fahrenheit/12 hour clock to Celsius/24 hour clock and vice versa.
2.11 Setting the Time
The display will flash after either:
a. Installing the battery or
b. Simultaneously pressing the Large Flame Button and Small Flame Button (buttons C & D fig. 1.1)
Press the Large Flame button (button C fig. 1.1) to set the hour.
Press the Small Flame button (button D fig. 1.1) to set the minutes.