ICON ATV08, User Manual, Page: 10 / 32

ICON EV Manual Assembly method and requirements ATV08 10
Installation of Headlight
Close the whole power supply, avoid the positive
and negative pole of the lamp wire from short-
circuit, install the headlight, and do not pull the
headlight, in order to avoid the lamp wire shedding,
causing unnecessary trouble.
1. Take out the Headlight and the front fender;
2. Align the hanger of the front fender with the hole
of the Headlightrack, fix the hexagonal M6 × 16
bolt inside the screw hole of the Front fork with
10mm opening wrench, and tighten the bolt.
Installation of Front fender
1. Take out the front fender, and fix the fender
hanger and Headlightrack on the Front fork
with hexangular M6 × 16 bolts;
2. Fix the pan head M5 × 14 screw and the front
fender stick on the corresponding positions
at both sides of the Front fork with the cross
screwdriver, and tighten the bolts, as shown.
When the lifting ear of the front fender is installed,
place the fender up as much as possible so as to
avoid interfering with the front tire.
Installation of Headlight and front fender
① Headlightrack
② Front fender hanger
③ Hexangular M6×16 bolt
and Ø6 flat gasket