ICON A5, Maintenance Manual

Page: 106 / 836

3-54 INSPECTIONS / GENERAL INSPECTION TASKS
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAP
TER
3
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
NA
Consumables
Tef-Gel
®
T
ASK
I
NSTRUCTIONS
:
1. Insert the rudder pedal release cable’s ball end into the slot in the release handle.
2. Pass the cable through the notch in the cable clip so that the jam nuts straddle the clip and can
clamp against it.
3. Adjust the jam nuts just to the point where there is no slack in the cable, then tighten them against
the clip.
4. Locate the seat pan in the position on the support structure and align the attachment holes.
5. Install the mounting hardware with Tef-Gel
®
. The forward two bolts are AN5C5A and the aft two
bolts are AN5C6A, each with an NAS1149C0563R washer under the head. Install all bolts finger
tight at first, then use a 1/2 wrench to torque each to 90 in-lb
f
.
6. Install the aft cockpit floor board on the appropriate side. (See “Cockpit Floor Board Installation”
on page 3-47.)
7. Zip up the control stick boot and install the cable tie around the top of the boot, snipping its free
end flush with flush-cutters.
V
ERIFICATION
M
ETHOD
:
The task is complete when the seat pan is installed.