ICON ProAudio Platform Nano Air, User Manual

Page: 82 / 115

82
! Only use the iMap and Firmware versions specific for yo ur hardware version.Also be sure to get
the newest iMap on the Icon Pro Audio website.
! Never unpack a .bin firmware file
<<<<<<<<< Fader Calibration – QCon Series >>>>>>>>>
We recommend that every QCon owner performs a fader calibration. The best values vary
according to the DAW of choice and preference. In the digital domain (in your DAW) valuescan
move from 0 to 100 in an instant, but physical faders need to actually travel from point A to point
B. Fader Calibration allows fine adjustment to the properties of how each motor fader responds
when commanded to move.
Press and hold the Rec Button on channel two and start the device. Fader Calibration will
display. Turn each Encoder Knob to fine tune the value for each channel. A higher value results in
smoother, quieter response. A lower value results in faster movement speed. Each fader can be
fine tuned individually. To adjust the master fader, use the channel select buttons 7 and 8. To save
the new changes and exit, press Encoder Knob 8.
For Logic Pro X, start with values set at 190, evaluate, then adjust individually to personal
preference.
<<<<<<<<< Fader Calibration – Platform (v2.00 and up) >>>>>>>>>
We recommend that every Platform owner performs a fader calibration. The best adjustment
varies according to the DAW of choice and preference. In the digital domain (in your DAW)
valuescan move from 0 to 100 in an instant, but physical faders need to actually travel from point A
to point B. Fader Calibration allows adjustment to the properties of how the motor faders respond
when commanded to move.
Press and hold the Encoder Knob on channel one and start the device. Turn Encoder Knob 8 to
adjust the total fader response. It is also possible to adjust a single fader by now holding down
Rec on channel three while adjusting the encoder of each channel. A higher value results in
smoother, quieter response. A lower value results in faster movement speed. To save the new
changes and exit, press Encoder Knob 8.
Start with a slower movement, test in your DAW and evaluate, then adjust individually to personal
preference.