16
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted.
To adjust the drive belt, you must remove the pedals,
the resistance knob, and the shields.
Using an adjustable wrench, turn the left pedal
clockwise and remove it. Then, turn the right pedal
counterclockwise and remove it.
Next, press the tabs
(A) on the sides of the
resistance control and
pull the Resistance
Knob (14) upward off
the resistance control.
See the EXPLODED DRAWING on page 19.
Identify the Left and Right Shields (9, 10). Remove the
four M3.5 x 19mm Screws (43) and the six M4 x 19mm
Screws (27) from the Left and Right Shields. Then,
remove the Left and Right Shields.
Next, loosen the two M10 Flange Locknuts (37)—one
on each side of the Eddy Mechanism (22). Then,
tighten the two M6 Nuts (38) until the Drive Belt (not
shown) is tight. When the Drive Belt is tight, tighten the
M10 Flange Locknuts.
When the drive belt is correctly adjusted, reattach the
shields, the resistance knob, and the pedals.
A
14
A
37
38
22
Summary of Contents for Weslo pursuit g 3.1
Page 4: ...4...
