10
9
40
40
49
33
3
A
A
1
9. Have a second person hold the Upright (3) near
the Frame (1).
Locate the wire tie (A) in the Upright (3). Tie
the lower end of the wire tie to the Reed Switch
Wire (33). Next, pull the upper end of the wire tie
until the Reed Switch Wire is routed through the
Upright.
Tip: To prevent the Reed Switch Wire (33)
from falling into the Upright (3), secure the
Reed Switch Wire with the wire tie (A).
Tip: Avoid pinching the Reed Switch Wire
(33). Slide the Upright (3) onto the Frame (1).
Attach the Upright (3) with three M8 x 20mm
Screws (40); start all the Screws, and then
tighten them. Then, slide the Upright Cover (49)
downward and press it into place.
Avoid pinching
the Reed Switch
Wire (33)
10. The Console (8) can use two AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert-
ing batteries. Otherwise, you may damage
the Console or other electronic components.
Remove the battery cover from the back of the
Console (8), and insert batteries into the bat-
tery compartment (B). Make sure to orient the
batteries as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
10
8
B
Summary of Contents for Weslo pursuit g 3.1
Page 4: ...4...
